Choose the primer route
Use Conversion Primer over suitable, sound existing antifouling, or the specified Light Primer epoxy system for the substrate. Marathon lists the 45441 conversion product as Silic Seal.
View Silic Seal View Light Primer
Hempel's Silic One 77450 is a biocide-free, high solid, fouling release coating. Based on silicone, a hydrogel microlayer provides a smooth, low friction surface that prevents organisms from attaching to the hull and propellers. The service life of Silic One on the hull is 2 years.
As a fouling release system for boats of glass fibre, steel, aluminium and plywood. For use below the waterline.
*Colours are for reference only and may appear different once painted
Hempel Silic One is a biocide-free fouling-release coating for use below the waterline. Its silicone and hydrogel surface makes it harder for organisms to attach firmly and helps growth release during movement or suitable cleaning.
Use as part of the specified coating system on suitable glass fibre, steel, aluminium and plywood surfaces.
A clean, low-friction surface helps reduce resistance through the water.
Reduced hull friction can support lower fuel use. Results depend on the boat and operating conditions.
Silicone fouling release without biocides or copper in the finish.
Suitable cleaning, inspection and planned recoating or an Infinity recharge keep the system maintained.
Switch between the three colours and two boat illustrations below.
Preview only: choose the colour and pack size for your order using the product options above. The graphic does not change your order selection. Screen colours are illustrative and may differ from the applied finish.
Silic One is the finish coat. Initial application requires the appropriate preparation, compatible primer and Silic One Tiecoat.
Use Conversion Primer over suitable, sound existing antifouling, or the specified Light Primer epoxy system for the substrate. Marathon lists the 45441 conversion product as Silic Seal.
View Silic Seal View Light PrimerThe silicone-based adhesion coat between the specified primer and Silic One. It is a separate stage and does not replace the epoxy primer.
View Silic One TiecoatA water-based recharger for an existing Silic One coating in good condition. Repair damaged layers before deciding on recharge or recoating.
View Hempel InfinityEnter the total underwater area to coat. The estimate uses Hempel’s theoretical spreading rate of 10 m² per litre per coat.
The 10% allowance is an adjustable example for practical losses, not a prescribed Hempel allowance. Results update as you change the figures.
Alternative single-size pack options, not a combined order. Pack counts round up to cover the estimate; no price or availability comparison is made.
Illustrative planning guide only. Use the measured total area, specified film thickness and current Hempel instructions. Actual consumption depends on surface condition, application method and losses. This calculates Silic One hull finish only; primer, Tiecoat, propeller work and repairs must be assessed separately.
Confirm the substrate, existing coating condition and full primer system before painting. Check the current product data sheet for temperature limits, film build and overcoating intervals. Silic One and Tiecoat are not for thinning; the current guidance gives a 60-minute pot life at 20°C.
Inspect and clean the coating as required. Use suitable soft cleaning methods rather than hard brushes or abrasive tools. Hempel offers a Silic One recoat route or Infinity recharge for suitable existing coating; maintenance needs depend on condition, use and time out of the water.
Silicone and hydrogel fouling release, explained by Hempel.
Open video on YouTubeExplore preparation routes, propeller kits, quantities and seasonal maintenance in the full buying guide.